![]() Material investment will remain the same, but more grading requires increased labor and use of additional equipment. The main cost factor when putting in any exterior or retaining wall is the amount of excavating and grading required to make the structure level. They are also versatile enough to be installed on a curve. Rock-face CMUs are more affordable, durable, and low-maintenance compared to other options like wood timber. The average rate of building a retaining wall out of concrete/cinder units is $10 to $15 per square foot. Consult with a professional for an estimate, because specific rates can vary greatly. However, interior walls may require more non-standard units with additional rock-face sides, which could increase material costs. Removing load-bearing requirements and eliminating grading and sealing work can reduce installation prices significantly. Interior walls are usually decorative in nature, built on a surface that is already level and not exposed to the elements. Interior and outdoor walls are less costly, but load-bearing requirements, grading, and excavation can increase costs. The most expensive installations are split-face veneer-typically on top of siding-foundations, and interior backsplashes. The type of finish on the side and the size of the project can drive up the cost. Rock-Face/Textured Block Installation CostsĪs mentioned above, split-face blocks cost $12 to $15 per square foot for installation, equipment, labor, and supplies, but these costs can increase depending on the type of project. Insulation: Better at resisting heat loss.ĭurability: Easy to maintain and extends life of structure.Įasy Installation: No tuck pointing, sealing, painting, or staining required. Mold & Mildew Prevention: Reduces potential moisture penetration. Green Building: Reduces the energy it takes to build the structure. Though it is more expensive, there are advantages to its use that may reduce total cost of ownership (TCO) compared to other building options: Price of materials, skilled labor, and installation make this type of veneer cost-prohibitive for most homeowners at more than three times the investment of other options. Note : Split-face veneer is also available in concrete but is not typically used for residential application. ![]() They will cost more than average models and can typically only be purchased through a licensed contractor. Non-standard units are chosen to be more aesthetically pleasing. They can also have different edge styles, like bullnose. They can be textured on one side and one end, on both faces, on both faces and one end, only on the end, etc. ![]() While a standard unit typically has one textured and three smooth sides, other styles are available. The actual dimensions are 7⅝-by-7⅝-by-15⅝ inches. Units are typically identified by their depth because that is the thickness of the structure they create, like a wall.Įxample : A standard CMU is 8-by-8-by-16 nominally. The nominal dimensions equal the actual dimensions plus the width of the mortar joint, usually about ⅜ inches. Like brick, CMUs have actual dimensions and nominal dimensions. Non-standard versions are available in other sizes and styles for $3 to $5 each. The price for standard units is about $3 each. ![]() Often referred to as a concrete masonry unit, or CMU, a standard split-face cinder block is 8-by-8-by-16 inches, made of concrete, and features a textured pattern on only one side. Find hiring guides, material costs, expert advice, how-to's and more.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |